FordParts
My Garage
My Account
Cart
OEM 2000 Lincoln LS Water Pump
H2O Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Water Pumps found
2000 Lincoln LS Water Pump Part Number: 2W9Z-8501-BB
$122.66 MSRP: $201.82You Save: $79.16 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Pump Assembly - Water; Engine Water Pump; Water Pump Assembly
- Manufacturer Note: With Gasket
- Base No.: 8501
- Item Weight: 2.70 Pounds
- Item Dimensions: 6.2 x 6.1 x 8.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2W9Z-8501-BB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Lincoln LS Water Pump Part Number: XW4Z-8501-CD
Product Specifications- Other Name: Pump Assembly - Water; Engine Water Pump; Water Pump Assembly
- Replaced by: 6U2Z-8501-E
- Base No.: 8501
- Item Weight: 5.30 Pounds
- Item Dimensions: 7.3 x 8.1 x 11.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XW4Z-8501-CD
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Lincoln LS Water Pump
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Lincoln LS Water Pump available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Lincoln LS Water Pump as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Lincoln LS Water Pump Parts Q&A
- Q: How to service and repair the water pump on 2000 Lincoln LS?A: Service and repair of the water pump requires first draining the engine cooling system. Begin by taking off the air cleaner outlet tube followed by engine vent hose separation before pulling away the upper radiator hose. Use the sequence to remove the heater supply hose and the water pump hose from the thermostat housing and the lower radiator hose. Start by removing the water crossover assembly followed by disconnecting the water inlet hose from the coolant outlet pipe as well as the water inlet hose from the pump. The heater water hose requires removal from connection to the water pump. The procedure continues by removing the belt idler pulley and its bracket before unclipping the wiring harness and unbolting the bracket using its two stud bolts and securing bolt. The removal process ends by first removing the bolt and then the studs before extracting the water pump assembly. The reverse steps of removal should be performed for installation.