FordParts
My Garage
My Account
Cart
OEM 2001 Lincoln LS Water Pump
H2O Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Water Pumps found
2001 Lincoln LS Water Pump Part Number: 2W9Z-8501-BB
$122.66 MSRP: $201.82You Save: $79.16 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Pump Assembly - Water; Engine Water Pump; Water Pump Assembly
- Manufacturer Note: With Gasket
- Base No.: 8501
- Item Weight: 2.70 Pounds
- Item Dimensions: 6.2 x 6.1 x 8.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2W9Z-8501-BB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Lincoln LS Water Pump Part Number: XW4Z-8501-CD
Product Specifications- Other Name: Pump Assembly - Water; Engine Water Pump; Water Pump Assembly
- Replaced by: 6U2Z-8501-E
- Base No.: 8501
- Item Weight: 5.30 Pounds
- Item Dimensions: 7.3 x 8.1 x 11.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XW4Z-8501-CD
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Lincoln LS Water Pump
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2001 Lincoln LS Water Pump available at FordPartsDeal.com. You can confidently purchase our OEM 2001 Lincoln LS Water Pump as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2001 Lincoln LS Water Pump Parts Q&A
- Q: How to service and repair the water pump on 2001 Lincoln LS?A: The service and repair procedure of the water pump begins with draining the engine cooling system. Start by taking off the air cleaner outlet tube followed by engine vent hose removal and upper radiator hose detachment. The service process starts with heater supply hose followed by water pump hose and lower radiator hose detachment from the thermostat housing. The water crossover assembly needs removal before disconnecting the water inlet hose from the coolant outlet pipe and the water inlet hose from the pump. The installer should disconnect the heater water hose which connects to the water pump. You must start by unclipping the wiring harness before taking out the two stud bolts and bolt to remove the bracket along with the belt idler pulley. The removal process ends with the extraction of the water pump assembly by taking out the bolt as well as the studs. To put it in place just do the opposite of what was done for removal.