FordParts
My Garage
My Account
Cart
OEM 2001 Lincoln LS Brake Pads
Disc Brake Pad Set- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Brake Pads found
2001 Lincoln LS Brake Pads, Front Part Number: YU2Z-2V001-JA
$50.07 MSRP: $74.98You Save: $24.91 (34%)Product Specifications- Other Name: Pad; Disc Brake Pad Set, Front; Front Pads; Disc Brake Pad Set
- Manufacturer Note: Ford Retail Spec
- Position: Front
- Replaces: 6W4Z-2001-BA, BRF-1402, XW4Z-2001-BA
- Base No.: 2001
- Item Weight: 4.90 Pounds
- Item Dimensions: 2.6 x 5.4 x 8.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: YU2Z-2V001-JA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Lincoln LS Brake Pads, Rear Part Number: XW4Z-2200-AA
Product Specifications- Other Name: Kit - Brake Shoe And Hardware; Disc Brake Pad Set, Rear; Disc Brake Pad Kit; Rear Pads; Kit - Brake Shoe And Lining; Disc Brake Pad Set
- Position: Rear
- Base No.: 2200
- Item Weight: 2.90 Pounds
- Item Dimensions: 5.5 x 3.9 x 4.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XW4Z-2200-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Lincoln LS Brake Pads, Rear Part Number: 4W4Z-2200-AA
Product Specifications- Other Name: Kit - Brake Shoe And Hardware; Disc Brake Pad Set, Rear; Disc Brake Pad Kit; Rear Pads; Kit - Brake Shoe And Lining; Disc Brake Pad Set
- Manufacturer Note: Warranty Eligible
- Position: Rear
- Base No.: 2200
- Item Weight: 3.50 Pounds
- Item Dimensions: 6.5 x 4.1 x 3.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4W4Z-2200-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Lincoln LS Brake Pads
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2001 Lincoln LS Brake Pads available at FordPartsDeal.com. You can confidently purchase our OEM 2001 Lincoln LS Brake Pads as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2001 Lincoln LS Brake Pads Parts Q&A
- Q: How to service the front brake pads on 2001 Lincoln LS?A: Start the front brake pad service by taking off the brake master cylinder filler cap to estimate brake fluid level in the reservoir then drain fluid to maintain half-full capacity. Support the vehicle while raising it and disconnect the wheel assembly from its position. It is essential to avoid inserting tools into the caliper sight hole since this action may harm the pistons. The brake hose needs suitable support during caliper removal to prevent it from hanging loose. Take all caliper bolts off then lift the caliper over the anchor plate. Replace brake pads when they reach the designated thickness area exceeding the metal rivets and plate backing or when they have worn down completely. Install new brake pads only with brand-new axle set components. Check pads for wear signatures before you remove them. Brake disc replacement is necessary when its thickness measurement shows out-of-spec values. A caliper inspection should be performed to detect leaks or boot damage because disassembly of the component will be required to repair either issue. The anchor plate assembly requires inspection to verify proper condition of guide pin boots and free movement of guide pins without damage but replacement of any faulty elements. A wood block or used pad should be placed between the caliper pistons and boots before using it to compress them. The installation procedure requires reversal of the removal steps by filling the brake master cylinder reservoir with new or equivalent DOT 4 brake fluid which adheres to Ford specification SAE-11704-DOT 4. You should use DOT 3 Brake Fluid (United States) C6AZ-19542-AB which matches Ford specification ESA-M6C25-A instead of DOT 4 brake fluid when the latter is not accessible.