FordParts
My Garage
My Account
Cart
OEM 2007 Ford E-150 Sway Bar Link
Stabilizer Sway Bar Link- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Sway Bar Link found
2007 Ford E-150 Stabilizer Link, Front Part Number: YC3Z-5K483-AA
$47.30 MSRP: $77.27You Save: $29.97 (39%)Product Specifications- Other Name: Link; Suspension Stabilizer Bar Link, Front; Suspension Stabilizer Bar Link Kit; Stabilizer Bar Link Kit; Sway Bar Link; Suspension Stabilizer Bar Link; Stabilizer Bar Link
- Manufacturer Note: 2WD
- Position: Front
- Replaces: F81Z-5K483-AA
- Base No.: 5K483
- Item Weight: 1.40 Pounds
- Item Dimensions: 19.1 x 6.2 x 0.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: YC3Z-5K483-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford E-150 Sway Bar Link
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford E-150 Sway Bar Link available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford E-150 Sway Bar Link as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Ford E-150 Sway Bar Link Parts Q&A
- Q: How to service the rear sway bar link on 2007 Ford E-150?A: Service of the rear sway bar and link starts with discarding the sway bar link nuts and bolts after taking off all two upper bolts and washers. The new bolts need to be tightened to 70 Nm (52 ft. lbs.) during installation. The service of the sway bar link starts with removal of its lower nuts, washers, and insulators which get discarded while new installation should be tight to 28 Nm (21 ft. lbs.). Remove the sway bar links with washers and insulators followed by the removal of sway bar bracket bolts to extract the two brackets and sway bar which you should discard the bolts. After retrofitting, tighten the bracket bolts to 40 Nm then follow reverse the removal process to finish the service.