FordParts
My Garage
My Account
Cart
OEM 2007 Ford Edge Alternator
Generator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Alternator found
2007 Ford Edge Alternator Part Number: 8G1Z-10346-A
$233.72 MSRP: $385.45You Save: $151.73 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Remanufactured Denso First Time Fit Alternator Assembly.
- Replaces: 7T4Z-10346-A
- Base No.: 10346
- Item Weight: 13.60 Pounds
- Item Dimensions: 12.5 x 10.1 x 8.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8G1Z-10346-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Edge Alternator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Edge Alternator available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Edge Alternator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Ford Edge Alternator Parts Q&A
- Q: How to service the alternator on 2007 Ford Edge?A: The service on alternators begins with disconnecting the battery terminal. Begin by removing the cooling fan and then use counterclockwise rotation of the accessory drive belt tensioner to set aside the accessory drive belt. After moving the generator protective cover you must remove the nut to expose and set aside the generator B+ terminal. Separate the generator electrical cable connection through unplugging its pin-type locking clips and wire harness. After removal of the generator stud nut install it at 47 Nm (35 lb-ft) torque. The generator stud removal should be followed by tightening it to 8 Nm (71 lb-in) at reinstallation. Crank off the generator bolt and take out the generator unit. The installation ends by following the removal steps in reverse and verifying every component is tight, while the generator B+ terminal should be taught to 12 Nm (9 lb-ft).