How to service the rear window wiper motor on 2007 Ford Expedition?

Question

Accepted Answer

The first step in servicing the rear window wiper motor requires removal of the rear wiper pivot arm together with the dust boot cover. When uninstalling the rear window wiper pivot shaft nut and handle keep note that tightness should be set to 18 Nm (13 lb-ft) during reinstallation. Open the liftgate glass to take off the nuts of the rear window striker and wiper pivot shaft assembly before installing them with a tightening force of 6 Nm (53 lb-in). Start the procedure by taking off the liftgate trim panel followed by closing the liftgate. New rear wiper motor installation requires beginners to unplug the liftgate window glass latch and power connection before taking off bolts and tightening them to 8 Nm (71 lb-in) during the installation sequence. To remove the rear window wiper motor start by disconnecting the electrical connector then removing the bolts before tightening them to 11 Nm (8 lb-ft) during reinstallation. During the new motor installation you should secure the liftgate window glass latch with bolts that must be tightened up to 8 Nm (71 lb-in). The striker should create an audible click during installation at the same time push the rear window wiper striker with pivot shaft assembly into the wiper motor and position the pivot shaft pin into the motor disc opening. Follow the installation instructions to integrate the rear wiper motor alignment tool from the new motor assembly which should establish fitting contact over the motor disc and striker assembly while keeping its clips correctly fastened. Connect all electrical wires to the rear wiper motor before securing it with 8 lb-ft torque to its mounting points followed by bolt tightening to 11 Nm. Use 6 Nm (53 lb-in) torque to fasten the rear window wiper striker and wiper pivot arm mounting assembly nuts which leads to carefully closing the liftgate glass and opening the liftgate. Liftgate sealed after installing the rear wiper pivot shaft nut and handle that requires a 18 Nm (13 lb-ft) torque setting and then attach the dust boot cover along with the rear wiper pivot arm. End the process by opening the liftgate while using the rear window wiper motor aligning tool to take out the tool then opening the liftgate glass before installing the liftgate trim panel followed by checking for normal liftgate and liftgate glass function.

OEM 2007 Ford Expedition Wiper Motor

3 Wiper Motors found

2007 Ford Expedition Wiper Motor Part Number: 6L1Z-17508-AARM

2007 Ford Expedition Front Transmission Part Number: 8L1Z-17508-A

2007 Ford Expedition Wiper Motor Part Number: 6L1Z-17508-AA

2007 Ford Expedition Wiper Motor

2007 Ford Expedition Wiper Motor Parts Q&A

Related 2007 Ford Expedition Parts

Alternate Year Models