How to service and repair the hood latch on 2007 Ford Freestar?

To service the hood latch, you will need to take out the 8 retainers and upper radiator shield and disconnect the secondary release cable. Record the latch position and then loosen the bolts to 12 Nm then take them out. You can unconnect the primary cable and, then, you can repeat all the steps, and make sure that the latch is properly engaged.

OEM 2007 Ford Freestar Hood Latch

Engine Hood Latch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Hood Latch found

View related parts
2007 Ford Freestar Lock, Front Part Number: 6F2Z-16700-AA
$31.12 MSRP: $42.34
You Save: $11.22 (27%)
ADD TO CART
Product Specifications
- Other Name: Latch Assembly - Hood; Hood Latch, Front; Latch; Hood Latch
- Manufacturer Note: Striker Is PIA To The 16612 Hood Assy
- Position: Front
- Replaces: 4F2Z-16700-AA
- Base No.: 16700
- Item Weight: 1.60 Pounds
- Item Dimensions: 6.7 x 5.4 x 2.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F2Z-16700-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2007 Ford Freestar Submodels:
- Base, Limited, S, SE, SEL, SES | 6 Cyl 3.9 L GAS, 6 Cyl 4.2 L GAS

2007 Ford Freestar Hood Latch

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Freestar Hood Latch available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Freestar Hood Latch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2007 Ford Freestar Hood Latch Parts Q&A

Q: How to service and repair the hood latch on 2007 Ford Freestar?
A: To service the hood latch, you will need to take out the 8 retainers and upper radiator shield and disconnect the secondary release cable. Record the latch position and then loosen the bolts to 12 Nm then take them out. You can unconnect the primary cable and, then, you can repeat all the steps, and make sure that the latch is properly engaged.