FordParts
My Garage
My Account
Cart
OEM 2008 Ford E-150 Turn Signal Switch
Turn Signal Indicator Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Turn Signal Switch found
2008 Ford E-150 Turn Signal Switch Part Number: 7F1Z-13K359-AB
$173.57 MSRP: $285.60You Save: $112.03 (40%)Product Specifications- Other Name: Switch Assembly - Direction Indicator; Steering Column Housing; Multi-Function Switch; Multifunction Switch
- Replaces: 5F1Z-13K359-AAA, SW-6523, 7F1Z-13K359-AA
- Item Weight: 1.00 Pounds
- Item Dimensions: 10.3 x 6.2 x 4.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7F1Z-13K359-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford E-150 Turn Signal Switch
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford E-150 Turn Signal Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford E-150 Turn Signal Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford E-150 Turn Signal Switch Parts Q&A
- Q: How to service and repair the turn signal switch on 2008 Ford E-150?A: One must start the turn signal switch service and repair operation by first disabling the supplemental restraint system (SRS). To access the ignition switch lock cylinder start by inserting your ignition key into the correct position then set the ignition switch to RUN position before using a punch to push the lock release tab while pulling out the cylinder. Perform the procedure of removing the tilt release lever or handle if present. The installation process requires you to start with screw removal of the upper and lower steering column shrouds and then remove both multi-function switch screws before tightening the new switch to 3 Nm (27 lb-inch). The electrical connectors for the multi-function switch must be disconnected before performing the reversal of installation steps. The completion of the procedure requires SRS repowering.