OEM 2008 Lincoln MKX Air Bag Sensor

2008 Lincoln MKX Air Bag Sensor Parts Questions & Experts Answers

• Q: How to service the Air Bag Sensor at the C-pillar on 2008 Lincoln MKX?

  A: Inspection and servicing of the side impact sensor mounted on the C-pillar begins by evaluating whether the vehicle has been involved in a crash. If no crash incidents are present a thorough examination of the restraints control module and impact sensor mounting points must be completed to check for damage. Repair all found damages. A new RCM system must be installed together with sensors before releasing the vehicle in any case to avoid potential fatal injuries. The air bag warning indicator becomes visible when the RCM fuse is disconnected during ON ignition switch operation because this condition is expected but does not signify a problem. A vehicle must be released to the public only after confirming that the SRS operates without any defects. When the problem continues the diagnostic process should start again after reinstalling the original part. The first step requires you to fold down the seat backrest of the rear section and then disable the SRS system. To access the side impact sensor you must first disconnect the quarter trim panel by pulling it out from the C-pillar area. Disconnect the electrical connector from the sensor by saving the tab positions for future reinstallation. After cleaning the connecting surfaces continue with the installation. Install the new sensor after removing both the side impact sensor and bolt by using 11 Nm (8 lb-ft) torque. Tighter bolt torque at 8 pounds feet will guarantee operability of restraint components for the RCM and impact sensor. Execute the opposite steps of removal to reestablish power to the SRS.