FordParts
My Garage
My Account
Cart
OEM 2009 Lincoln MKX Air Bag Sensor
Air Bag Impact Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Air Bag Sensors found
2009 Lincoln MKX Side Impact Sensor, Rear Part Number: 7T4Z-14B345-A
$36.54 MSRP: $49.73You Save: $13.19 (27%)Product Specifications- Other Name: Sensor - Side Air Bag; Air Bag Impact Sensor, Front, Rear; Air Bag Sensor; Side Sensor
- Position: Rear
- Base No.: 14B345
- Item Weight: 0.30 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-14B345-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Lincoln MKX Front Impact Sensor Part Number: 7T4Z-14B004-A
$215.91 MSRP: $293.81You Save: $77.90 (27%)Product Specifications- Other Name: Sensor Assembly; Air Bag Impact Sensor; Air Bag Sensor; Front Sensor
- Base No.: 14B004
- Item Weight: 0.40 Pounds
- Item Dimensions: 9.3 x 6.3 x 1.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 7T4Z-14B004-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Lincoln MKX Air Bag Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Lincoln MKX Air Bag Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Lincoln MKX Air Bag Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Lincoln MKX Air Bag Sensor Parts Q&A
- Q: How to service the Air Bag Sensor at the C-pillar on 2009 Lincoln MKX?A: Service of the side impact sensor at the C-pillar starts with folding down the rear seat backrest followed by turning off the Supplemental Restraint System (SRS). Remove the rear scuff plate together with the locator pin and place the quarter trim panel to the side. The retaining clip of the side impact sensor will become available after pulling the quarter trim panel forward at the C-pillar. The electrical connector ought to be detached from the side impact sensor to continue. A failure to properly tighten the fasteners of the restraints control module (RCM) and impact sensor according to specification could result in fatal injuries or death during crashes due to incorrect restraint system operation. Take note of where the two locating tabs should be positioned then check that both C-pillar and side impact sensor surfaces are debris-free and clean. When replacing a side impact sensor you should remove the bolt first together with the sensor along with torqueing the new sensor to 11 Nm (97 lb-in). After completing removal you should repower the SRS while testing its complete functionality until no faults are detected before you release the vehicle to its owner.