FordParts
My Garage
My Account
Cart
OEM 2009 Ford Flex A/C Accumulator
Accumulator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 A/C Accumulator found
2009 Ford Flex Dehydrator Part Number: BG1Z-19959-B
$53.85 MSRP: $88.60You Save: $34.75 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Dehydrator Assembly; A/C Receiver Drier; Drier Desiccant Element; A/C Accumulator; Accumulator; Drier
- Replaces: 8G1Z-19C836-A, AG1Z-19959-A, BG1Z-19959-A, YL-197, 8A5Z-19959-A, 8G1Z-19C836-B, 8A5Z-19959-B, YL-202, YL-193, YL-206, YL-195
- Base No.: 19C836
- Item Weight: 2.70 Pounds
- Item Dimensions: 8.5 x 21.6 x 10.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: BG1Z-19959-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Flex A/C Accumulator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Flex A/C Accumulator available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Flex A/C Accumulator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Flex A/C Accumulator Parts Q&A
- Q: How to Service and Repair the A/C Accumulator on 2009 Ford Flex?A: The A/C accumulator servicing and repair process needs controlled exposure to outside air for removal and installation while deployment of the accumulator must occur after other components in multi-component A/C repairs. The shipping caps should stay installed until fittings are ready for connection while immediate evacuation of the A/C system becomes necessary to stop moisture from contaminating the desiccant. A new accumulator must be replaced only when the ailing A/C compressor causes system contamination or when physical damages appear on the shell or desiccant due to exceeding one hour of pressure equalization with outside air. You should not replace the accumulator during repair when there is present any positive refrigerant pressure. Begin by evacuating the refrigerant before separating the condenser outlet fitting nut and minus adapter while discarding the O-ring and gasket seals so tighten the new components to 15 Nm (133 lb-in) upon installation. The accumulator outlet line clip needs removal to disconnect the fitting by unfastening its bolt, discard the O-ring seal and gasket seal before tightening the new fitting to 15 Nm (133 lb-in) torque. The two accumulator bolts should be removed before installation of new ones at 9 Nm (80 lb-in). The installation requires following the removal steps in reverse order and including the installation of replacement gasket and O-ring rubber seals and precise PAG oil addition to the refrigerant system before evacuating the system and performing leak tests and final charger.