Service repair starts with removing door trim panel along with watershield before proceeding with the front door latch operations. The front door requires removal of its latch remote control function. The process requires taking off retaining nuts plus interior handles and external bezels from side hinged along with rear doors. During unit setup it is necessary to drill out the power door lock actuator rivet if equipped. The lock cylinder lever requires disconnecting from the lock cylinder rod for front and side hinged door service. Front and side hinged doors also need outside
Door Handle-to-latch rod separation at the door latch point. To work on the rear door start by removing its license plate housing screws followed by pulling the housing off the door before disconnecting both the door handle-to-latch cable and the lock cylinder rod at its respective components. So move ahead by removing the bolts that retain the door latch. When dealing with rear and side hinged doors you must take out the door latch remote control screw. The installation process begins by removing the front door assembly containing the door latch along with its latch remote control cable and lock cylinder rod together with push-button rod and power door lock actuator. Similar actions must be taken for the side hinged and rear doors. The procedure for installation runs in reverse order to removal steps.