Other Name: Sensor - Fuel Injector Pressure; Fuel Tank Pressure Sensor; Fuel Pressure Sensor
Fits the following Lincoln Models:
Aviator | 2020-2023 | Base, Black Label, Black Label Grand Touring, Grand Touring, Livery, Reserve | 6 Cyl 3.0 L GAS, 6 Cyl 3.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Nautilus | 2019-2023 | Black Label, Reserve, Select | 6 Cyl 2.7 L GAS
Q: How to service and repair the fuel pressure sensor on Lincoln Continental?
A: A repair or service of the fuel pressure sensor requires a first step to disconnect the battery ground cable. Appropriate safety practices demand avoiding smoking combined with the prevention of using lighted tobacco and all open flames while near fuel system components due to the dangerous fiammable mixture that may result in personal injury. The release of fuel pressure becomes essential when performing the procedure for fuel pressure sensors and fuel injection supply manifolds that are both present on the engine. Both steps must be completed before you disconnect the fuel pressure sensor: first separate the vacuum line from the sensor and then disconnect its electrical connection. Begin by unscrewing the fuel pressure sensor then remove it while checking O-rings before making replacement as necessary. Use clean engine oil that fulfills Ford specification WSS-M2C153-G instead of silicone grease when reinstalling the components since silicone can cause fuel injector blockage. The installation process demands that both the fuel pressure sensor sealing area and the fuel injection supply manifold sealing area be cleaned thoroughly before finalizing the installation procedure.
Q: How to Service the Fuel Pressure Sensor on Lincoln Navigator?
A: The service procedure for the fuel tank pressure sensor requires removal of the fuel tank followed by disconnecting its electrical connector. A correct method for servicing the fuel tank pressure sensor includes pushing down and rotating the sensor counterclockwise so we avoid damaging both the sensor and fuel tank. You should push down the sensor before turning it in a counterclockwise direction to remove it from the fuel tank. In order to install follow the steps in reverse from removal. After performing the installation conduct both a system leak test and evaporation emission repair verification drive cycle procedure to check for proper operation.
Q: How Can You Safely Service the Fuel Pressure Sensor and Temperature Sensor on Lincoln Town Car?
A: Disabling the fuel rail pressure and temperature sensor requires caution due to highly flammable mixtures present that pose serious injury risks. Therefore avoid all contact of smoking with fuel components as well as use of open flames or lighted tobacco proximity to these components. Personal electronic devices such as cell phones need to stay away from within the range of fuel components because they create similar safety hazards. The first step should include releasing fuel system pressure and then disconnecting the battery ground cable. To start the replacement disconnect both the electrical connector and vacuum connector from the fuel rail pressure and temperature sensor. Unscrew the two bolts from the sensor then remove it from its place. Replace the old O-ring seal and install a fresh one by putting clean engine oil on its surface. For the sensor installation completion proceed in reverse order of removal while torquing the sensor to 5 Nm (44 lb-in).