Other Name: Control Unit; Fuel Pump Driver Module; Fuel Pump Controller
Manufacturer Note: Used For Fuel Pump Relays
Replaces: CU5Z-9D370-E
Fits the following Lincoln Models:
MKC | 2015-2016 | Base, Black Label, Premiere, Reserve, Select | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L GAS
MKZ | 2013-2020 | Base, Black Label, Black Label Hybrid, Hybrid, Premiere, Reserve, Reserve I, Reserve II, Select | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 6 Cyl 3.7 L GAS
Other Name: Control Unit; Fuel Pump and Sender Assembly; Fuel Pump Driver Module; Fuel Pump Controller; Control Assembly; Controller
Fits the following Lincoln Models:
Aviator | 2020-2023 | Base, Black Label, Black Label Grand Touring, Grand Touring, Livery, Reserve | 6 Cyl 3.0 L GAS, 6 Cyl 3.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Other Name: Control Unit; Fuel Pump Driver Module; Control Module; Fuel Pump Controller
Manufacturer Note: Used For Fuel Pump Relays
Fits the following Lincoln Models:
Continental | 2017-2020 | 80th Anniversary Coach Door Edition, Black Label, Coach Door Edition, Reserve | 6 Cyl 3.0 L GAS
MKC | 2017-2019 | Base, Black Label, Premiere, Reserve, Select | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L GAS
MKX | 2016-2018 | Black Label, Premiere, Reserve, Select | 6 Cyl 2.7 L GAS, 6 Cyl 3.7 L GAS
MKZ | 2017-2020 | Base, Black Label, Black Label Hybrid, Hybrid, Premiere, Premiere Hybrid, Reserve, Reserve Hybrid, Reserve I, Reserve I Hybrid, Reserve II, Reserve II Hybrid, Select, Select Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 6 Cyl 3.0 L GAS
Nautilus | 2019-2023 | Base, Black Label, Reserve, Select | 4 Cyl 2.0 L GAS, 6 Cyl 2.7 L GAS
Q: How to service the Fuel Pump Driver Module (FPDM) on Lincoln Mark LT?
A: The service process for Fuel Pump Driver Module (FPDM) starts with putting the vehicle in NEUTRAL position on a hoist then lowering the spare tire. Detach the electrical connector of the Fuel Pump Driver Module before removing all bolts which secure the module. Installation of the new Fuel Pump Driver Module requires bolt tightening to 10 Nm (89 lb-in) according to the removal procedure for correct assembly.
Q: How to service the Fuel Pump Driver Module (FPDM) on Lincoln Navigator?
A: You should begin servicing the Fuel Pump Driver Module (FPDM) by having the vehicle in NEUTRAL position on a hoist while removing the battery ground cable. Connectors and hardware bolts leading to the Fuel Pump Driver Module (FPDM) are situated near the fuel tank filler pipe on the top of the left-hand frame rail. Disconnect the electrical connector and remove the bolts to remove the FPDM. Install the new FPDM by tightening its bolts to 10 Nm (89 lb-in) then perform the reverse steps for removal to finish the installation process.