The process of servicing the rear door window motor starts with taking out the rear door trim panel and the access hole plugs. Hammer the motorless door window unit to a reachable position next to the access holes. Then loosen the glass clamp bolts using a preventative measure to tighten them to 6 Nm (53 lb-in) following reinstallation. The window should be taped into position before lowering the
Window Regulator to stop at the tracks' lower points. The door speaker must be uninstalled followed by removal of the
Interior Door Handle screw which requires setting the door handle aside. To start the window installation process workers must first disconnect the wiring harness retainers before taking off the wiring harness cover plate and disconnecting the two door latch cable retainers. When reinstalling the bolts remove the ten bolts from the door module and fasten them to a torque of 11 Nm (8 lb-ft). Remove the rear door module assembly by disconnecting its electrical connector followed by the transferring of essential components if replacing it with a new module. The reverse sequence should be performed to finish installing the system.