FordParts
My Garage
My Account
Cart
OEM Mercury Mountaineer Blend Door Actuator
Air Blend Door Actuator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
6 Blend Door Actuators found
Mercury Mountaineer Motor Assembly Part Number: YL5Z-19E616-AA
$42.48 MSRP: $68.55You Save: $26.07 (39%)
Mercury Mountaineer Motor Assembly Part Number: F77Z-19E616-BA
$130.46 MSRP: $177.54You Save: $47.08 (27%)
Mercury Mountaineer Motor Assembly Part Number: F7DZ-19E616-BA
Mercury Mountaineer Actuator Part Number: 2L2Z-19E616-BA
Mercury Mountaineer Motor Assembly Part Number: F87Z-19E616-AA
Mercury Mountaineer Adjust Motor, Rear Part Number: 1L2Z-19E616-BA
$41.47 MSRP: $64.73You Save: $23.26 (36%)
Mercury Mountaineer Blend Door Actuator
OEM Blend Door Actuator boasts unmatched quality. Each part goes through full quality checks. They adhere to Mercury's official factory standards. These steps remove flaws and inconsistencies. So you can get Blend Door Actuator with long life and a perfect fit. Come to our website and find genuine Mercury Mountaineer parts. We keep a wide inventory of OEM Mountaineer parts at the highly affordable prices. It's easy to search, compare, and pick what you need. You'll love the clear info and simple checkout. We offer top-rated customer service, and we reply fast. We also ship promptly to ensure your order arrives on time.
Mercury Mountaineer Blend Door Actuator Parts and Q&A
- Q: How to service the LH temperature blend door actuator on Mercury Mountaineer?A:Service of the LH temperature blend door actuator begins by removing the instrument panel first. The first step involves removing the LH floor duct by unfastening its two retaining screws. Screw removal of three fasteners will reveal the LH temperature blend door actuator before removing its electrical connector. You must remove the LH temperature blend door actuator as the last step. The installation process of the new actuator follows the opposite sequence of removal procedures.
- Q: How to service and repair the right-hand temperature blend door actuator for the Dual Automatic Temperature Control (DATC) on Mercury Mountaineer?A:Before servicing or repairing the right-hand temperature blend door actuator of the Dual Automatic Temperature Control (DATC) system it is necessary to deactivate the supplemental restraint system. Start by removing trim panels from both right-hand and left-hand A-pillar and then continues with the cowl panel grille. When removing the instrument panel defroster grille move the sunload sensor electrical connector only enough to reach it without damaging the connector. The instrument panel bolt needs removal from outside the vehicle yet should remain partially in place for moving the right-hand side of the panel beyond its dash panel position. Support the instrument panel correctly to protect wiring components from harm while avoiding powerful movements of the panel. Instal threaded rods as equivalent supports with matching dimensions and thread measurement to replace the support bolts which secure the instrument panel. Start by removing support bolts from the instrument panel after correct positioning of the equipment. Then use the support bolts to extract the instrument panel from its installed position near the dash panel. The installation of the actuator requires performing the opposite steps to removal.
Related Mercury Mountaineer Parts
Mercury Mountaineer A/C Accumulator
Mercury Mountaineer A/C Compressor
Mercury Mountaineer A/C Compressor Cut-Out Switches
Mercury Mountaineer A/C Condenser
Mercury Mountaineer A/C Idler Pulley
Mercury Mountaineer A/C Switch
Mercury Mountaineer A/C System Valve Core
Mercury Mountaineer Blower Control Switches
Mercury Mountaineer Blower Motor
Mercury Mountaineer Evaporator
Mercury Mountaineer HVAC Control Module
Mercury Mountaineer Heater Core