My Garage
Cart
Make sure this part fits

Ford 8F9Z-5421813-A
Lock Assembly, Front Driver Side

2005-2009 Ford 8F9Z5421813A

Customer Questions & Expert Answers (11)
Ford 8F9Z-5421813-A Lock Assembly, Front Driver Side
  • Part Description
    Latch; Door Latch Assembly, Front Left; Door Lock
  • Base No.
    <21812
  • Position
    Front Driver Side
  • Manufacturer
    Ford
Make sure this part fits
$41.39 MSRP: $59.22
You Save: $17.83 (31%)
Currently Unavailable

Due to manufacturer supply shortage, this item isn't currently available for ordering.

  • Vehicle Fitment

    Year Make Model Trim Engine
    2005-2007 Ford Five HundredLimited, SE, SEL6 Cyl 3.0 L GAS
    2005-2007 Ford FreestyleLimited, SE, SEL6 Cyl 3.0 L GAS
    2008-2009 Ford TaurusLimited, SE, SEL6 Cyl 3.5 L GAS
    2008-2009 Ford Taurus XEddie Bauer, Limited, SEL6 Cyl 3.5 L GAS
    2005-2007 Mercury MontegoLuxury, Premier6 Cyl 3.0 L GAS
    2008-2009 Mercury SableBase, Premier6 Cyl 3.5 L GAS
    Warning: California's Proposition 65
  • Customer Questions & Expert Answers

    Q:
    Will this 8F9Z-5421813-A work in my car? Posted by FordPartsDeal Specialist
    A:
    Select Your Vehicle model to verify if part number 8F9Z-5421813-A fits your car.
    Posted by FordPartsDeal Specialist
    Q:
    What should be done with the bolts holding the rear door module for the 2005 Ford Freestyle? Posted by Customer
    A:
    Remove the 10 bolts holding the rear door module and set it aside, tightening these bolts to 8 Nm (71 lb-in) during reinstallation.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What should be done with the glass clamp bolts for the 2005 Ford Five Hundred? Posted by Customer
    A:
    Loosen the two bolts and secure the window fully up with tape, tightening the bolts to 8 Nm (71 lb-in) during reinstallation.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What should be ensured before connecting the exterior door handle actuating rod for the 2006 Ford Five Hundred? Posted by Customer
    A:
    Ensure the exterior door handle and latch are installed and tightened.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What are the last steps for the interior door handle and trim panel for the 2007 Ford Freestyle? Posted by Customer
    A:
    Position the interior door handle, loosely install the bolt, and finally install the front door interior trim panel, center the inside door handle alignment pins to the front door trim panel, and install the interior door handle bolt, tightening it to 7 Nm (62 lb-in).
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What is the next step after securing the window for the 2009 Ford Taurus? Posted by Customer
    A:
    Remove the door lock cylinder circlip and set the front door lock cylinder rod and pawl aside.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What is the last step regarding the window glass for the 2009 Ford Taurus? Posted by Customer
    A:
    Untape the window glass, lower it, and install the window glass clamp bolt, ensuring the window is positioned in the clamp and fully forward, tightening it to 8 Nm (71 lb-in).
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What is the final step for securing the rear door latch assembly for the 2008 Ford Taurus X? Posted by Customer
    A:
    Install the three rear door latch assembly-to-rear door module bolts, tightening them to 12 Nm (9 lb-ft), then install the push button rod on the rear door latch assembly and connect the rear door latch assembly electrical connector.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What should be done with the exterior door handle and actuating rod for the 2007 Mercury Montego? Posted by Customer
    A:
    Ensure the exterior door handle and door latch are installed and tightened to specification before connecting the exterior door handle actuating rod with the yellow clip.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What should be done after connecting the push button rod for the 2006 Mercury Montego? Posted by Customer
    A:
    Connect the door ajar switch and door lock actuator electrical connectors.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What should be disconnected after removing the door module for the 2008 Mercury Sable? Posted by Customer
    A:
    Disconnect the door ajar switch and door lock actuator electrical connectors, then disconnect the push button rod from the front door latch.
    Posted by FordPartsDeal Specialist
    See expert answers on similar Door Latch Assembly
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

OEM Ford Lock Assembly, Front Driver Side 8F9Z-5421813-A Designed for Proper Fit and Performance

The Ford part 8F9Z-5421813-A Lock Assembly, Front Driver Side as a genuine Ford Door Latch Assembly component delivers both authenticity and reliability. This item carries a warranty from the manufacturer which guarantees 12-month, 12,000-mile of use. The Ford 8F9Z-5421813-A Lock Assembly, Front Driver Side is used with Ford Taurus, Five Hundred, Freestyle vehicles and Mercury Montego, Sable models. The original Ford part will bear the manufacturer part number: 8F9Z-5421813-A and where it is made at Ford. It has been specifically developed to fit the Front Driver Side and has the code: <21812.
This component has dimensions of 6.2 x 4.6 x 4.5 inches and its weight is approximately 1.20 Pounds. The part 8F9Z5421813A is available in New condition while meeting the standards of the product rating. The Latch; Door Latch Assembly, Front Left; Door Lock belongs to the Direct Replacement category to guarantee it is suitable for its specific vehicle applications. This part 8F9Z-5421813-A can be known as Lock; Door Latch Assembly. The inventory reference for this item is SKU: 8F9Z-5421813-A. The Ford manufacturer issues a factory warranty for this component which ensures dependable operation and peak performance. You can find delivery and returns information on our Shipping Policy and Return Policy pages.
Original equipment manufacturer parts are of the top standards and their performance is outstanding and top notch. This is explained by the fact that they follow the official manufacturing techniques of Ford, use of premium material and meets high standards of quality. Our site is worth visiting, in case you need high-quality and affordable OEM Ford components. We promise the optimal priced Ford parts on a wide range. You can relax that all OEM products you buy from us include a manufacturer warranty and will be covered by our simple and easy-to-use return policy, so you will not worry about buying a part.