Ford JL1Z-17664-A
Washer Pump

You must start windshield washer pump repair by unplugging the right-hand front fender splash shield. Spare no effort to follow the product label warnings alongside seeking medical help for any medical emergency which disregarding instructions can produce severe personal injuries. The service requires emptying the washer reservoir because removing the washer pump requires the fluid reservoir to be empty. Detach the electrical connector with the hoses before removing the washer pump assembly. Operating the washer pump must be avoided prior to the washer reservoir filling because it may trigger early pump failure. The new washer pump installation involves returning the steps of removal while filling the washer reservoir with windshield washer fluid.

Service and repair of the windshield washer pump starts with placing the vehicle on a hoist in NEUTRAL gear before uninstalling the RH front fender splash shield. Read all product labels for emergency advice and consult the available Material Safety Data Sheet (MSDS) before working as failure to follow instructions could result in severe personal injury. Drain the washer reservoir contents before removing the washer pump since it prevents washer fluid from spilling. Begin by disconnecting electrical connectors together with hoses before you uninstall the windshield washer pump. Operation of the washer pump must wait until after filling the washer reservoir since early pump failure could occur if done prematurely. The installation of the new washer pump requires the original steps to be followed backward along with proper fluid filling in the washer reservoir followed by careful grommet protection during assembly.

Service of windshield washer pump should begin by removing the RH front fender splash shield. Avoid damage to the rubber grommet when carrying out the replacement procedure. The procedure to prevent windshield washer fluid spills requires you to drain the reservoir before taking off the washer pump. Start the procedure by disconnecting electrical elements along with washer pipe connections followed by taking off the washer pump. Operating the washer pump before filling the washer reservoir would result in early pump failure therefore it is important to refrain from doing so. The installation process of the new pump requires you to perform the opposite removal procedures and add windshield washer fluid to the reservoir.

The windshield washer pump repair process starts with hoisting the vehicle into NEUTRAL position before removing the RH front fender splash shield. Before working on these components read the product label warnings and MSDS sheet because breaking these instructions may cause severe personal injuries. When installing the new washer pump users should empty the reservoir first to stop fluid leaks and protect the grommet with its rubber material during replacement. Start the replacement by disconnecting the electrical connection and the tubes and subsequently remove the windshield washer pump unit. Operating the pump before filling the windshield washer reservoir should be avoided because premature pump failure will occur. Reinstallation ends with filling the windshield washer fluid reservoir with windshield washer fluid while following the removal reversal steps.

Begin by removing the RH front fender splash shield.

Reverse the removal steps and fill the windshield washer reservoir with windshield washer fluid.