Ford F6DZ-6565-AA
Push Rods

First wash the push rod and clear its oil passage with compressed air after soaking it in appropriate fluid. The examination of push rod endings will reveal nicks as well as grooves and rough surfaces or appreciable wear. In this case you need to replace the push rods with new ones. Inspection of push rods happens either by rotating them with the valve closed or through a Dial Indicator with Bracketry for precise measurement while they are installed in the engine. The replacement of an affected push rod with a new component becomes necessary when the specifications show its bending exceeds recommended measurements.

The rocker arm needs to be removed first to access the push rod for service operations. The correct placement of push rods needs precise identification because they need installation according to their initial positions. After taking out the push rods you should reinstall them by undertaking the reversal of the removal steps.

Clean procedures become crucial during engine repairs because extraneous objects from cleaning gaskets can result in automatic transmission failure. Begin the process by taking out rocker arms while making notes to remember the original position of each push rod which needs to be restored afterward. Place clean engine oil on push rods before reinstalling them according to the reverse order of removal steps.

The first step for servicing push rods requires removal of rocker arms. The correct placement of each push rod should be noted because reinstallation in original positions reduces early wear on the components. Note down the positions of all push rods before starting their removal process. Reviving the removal steps will allow you to install the components.

Dealing with push rods requires first removing rocker arms as a starting point. Proper identification of each push rod's location becomes important since they need to return to their original installation spots to avoid early wear. Take note of push rod positions before removing them altogether. Installation of push rods should be performed by reversing all steps from removal.

Start service and repair of the push rod by removing the rocker arms. The correct installation location for push rods needs to be understood because the rods should return to their original positions. Note down the locations of all push rod pieces before moving forward with their removal. The installation of push rods requires you to perform the removal procedure in reverse order.

It must be replaced with a new push rod.

The push rods should be lubricated with clean engine oil before proceeding with installation.

Begin by cleaning them in a suitable solvent and using compressed air to blow out the oil passage.

Inspect the ends of the push rods for nicks, grooves, roughness, or excessive wear.

Proceed to remove the push rods.