OEM 2006 Ford E-250 Crankshaft Position Sensor

2006 Ford E-250 Crankshaft Position Sensor Parts Questions & Experts Answers

• Q: How to Service the Crankshaft Position Sensor on 2006 Ford E-250?

  A: A technician must start crankshaft position (CKP) sensor servicing by securing the vehicle in neutral gear position on a hoist. The first action involves disconnecting the battery ground cable followed by taking off the splash shield from the system. Start by removing the accessory drive belt from the pulley followed by disconnecting and detaching the electrical connector of the CKP sensor while placing the wiring harness safely to the side. You need to slide down the A/C compressor 1 inch after you disconnect the wiring harness from the bracket and unplug the A/C compressor electrical connector but do not remove the bolts. The CKP sensor bolt needs removal with its sensor along with an assessment of the O-ring for damages followed by a new seal if required. Pre-installation oiling with clean engine oil of the O-ring seal must be performed. The installation process requires CKP sensor bolt tightening to 10 Nm (89 lb-in) while setting the A/C compressor bolts to 25 Nm (18 lb-ft) before proceeding with the reverse removal steps.