OEM 2006 Ford Ranger Air Bag Control Module

2006 Ford Ranger Air Bag Control Module Parts Q&A

• Q: Is the Orientation of the Air Bag Control Module Critical for the Correct Operation of the Supplemental Restraint System (SRS) on 2006 Ford Ranger?

  A: A correct orientation of restraints control module (RCM) becomes essential for proper operation of the air bag supplemental restraint system (SRS). A vehicle with SRS requires replacement of the RCM in cases where damage affects its mounting bracket or deforms the center tunnel. The RCM will still need replacement even in situations where air bags did not deploy. Primary maintenance includes restoring the damaged part to its original state. Use safety glasses during every interaction with SRS vehicles and air bag modules to protect from possible accidental deployment injuries. Vehicle sensor mounts must be checked for collisions-induced damage following accidents before replacing an SRS component that requires repositioning. Memory saver devices should not be used because they increase the risk of personal injury. Static electricity poses a problem to electronic modules because they remain sensitive to this electric charge. The RCM fuse removal during an ON ignition state will trigger the air bag warning lamp to illuminate as confirmation of proper SRS functionality. The vehicle must be given back to customers after a thorough check confirms a fault-free state for the SRS system. Implementation of new parts represents the appropriate repair method yet the diagnostic process needs repeat execution after reinstalling the original part when the issue continues to occur. To begin, depower the system. High-series floor console models should have their floor console dismounted before beginning work. Start by taking out the consolette tray mat from vehicles with consolettes before uninstalling its four screws and the consolette tray. The next step requires users to release the RCM electrical connector locking clip through sliding action before discharging the RCM electrical connector. Correct torque values must be applied when tightening the RCM bracket retaining bolts since users must first remove the three bolts and RCM followed by installing the new RCM before securing it to 12 Nm (9 lb-ft). Rephrase the procedure by reinstalling everything then reboot the system.