FordParts
My Garage
My Account
Cart
OEM 2006 Lincoln Town Car Turn Signal Switch
Turn Signal Indicator Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Turn Signal Switch found
2006 Lincoln Town Car Multifunction Switch Part Number: 7W1Z-13K359-AA
$96.69 MSRP: $159.09You Save: $62.40 (40%)Product Specifications- Other Name: Switch Assembly - Direction Indicator; Combination Switch; Multi Purpose Switch
- Replaces: 5W1Z-13K359-AA
- Base No.: 13K359
- Item Weight: 3.30 Pounds
- Item Dimensions: 5.9 x 4.5 x 10.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7W1Z-13K359-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Lincoln Town Car Turn Signal Switch
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Lincoln Town Car Turn Signal Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Lincoln Town Car Turn Signal Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Lincoln Town Car Turn Signal Switch Parts Q&A
- Q: How to service and repair the turn signal switch on 2006 Lincoln Town Car?A: The first procedure in servicing and repairing the turn signal switch includes disabling the supplemental restraint system (SRS). First position the ignition switch lock cylinder to RUN then insert a suitable tool to push and pull simultaneously on the cylinder release tab until it comes loose from its housing. Proceed by taking out the tilt release lever/handle. The driver can begin by pushing the shroud sides inward to expose its upper steering column shroud system and then remove the three screws which secure the upper and lower steering column shrouds. The owner must re-tighten these screws to 2 Nm (18 inch lbs.) when reinstalling. To install the multi-function switch requires disconnecting its three electrical connectors before removing both holding screws that need to be tightened at 3 Nm (27 inch lbs.) during installation. Reverse the removal method to establish power for the supplemental restraint system (SRS).