OEM 2008 Ford Explorer Brake Master Cylinder

2008 Ford Explorer Brake Master Cylinder Parts Q&A

• Q: How to Ensure Proper Functioning of the Brake Master Cylinder on a 2008 Ford Explorer?

  A: Service and repair of the brake master cylinder starts with draining the fluid reservoir through a suitable suction device. You should disconnect the brake fluid level warning switch electrical connector after which you should remove and tighten two brake tube fittings from the brake master cylinder to 18 Nm (13 lb-ft). You should remove first the two brake master cylinder nuts as well as the square cut seal before installation where both components require a torque of 25 Nm (18 lb-ft). Proper installation of the square cut seal remains essential because improper placement can result in wrong brake pedal sensations. Bleed the brake system while executing the opposite removal steps. Clean seamless brake fluid that adheres to manufacturer guidelines should always be used because using drained fluid can cause component damage alongside fluid contamination. The special cautions involve clearing up brake fluid spills from painted and plastic surfaces by washing them instantly with water. Ford/Motorcraft products require emergency medical inquiries at telephone number 1-800-959-3673 while the product Material Safety Data Sheet (MSDS) should be consulted if available.