OEM 2008 Ford Explorer Brake Pads

2008 Ford Explorer Brake Pads Parts Q&A

• Q: How to service and repair front brake pads on 2008 Ford Explorer?

  A: The front brake pad service requires brake fluid which meets manufacturer requirements while rejecting previously drained fluid because contamination can cause damage to components. For proper braking performance install new brake shoes or pads on both ends of all wheel axles. The first step should be checking the brake fluid in the brake master cylinder reservoir before removing fluid to reach a half-full mark. Start by taking off the wheel in combination with the tire. The brake caliper sight hole must be avoided for piston retraction because damage can occur and the brake caliper must not hang from the brake hose to prevent hose damage. Detach the two brake caliper guide pin bolts while placing the caliper to the side with mechanic's wire support. Check the brake pads for wear and contamination while inspecting the brake disc and perform machining when required for replacement. Discard the clips while you remove the brake pads together with them. New brake pad installation requires pad lining material to stay free from contacting any substances like grease, oil or brake fluid and contaminants. Both sides of the vehicle need brake disc pads which come in the kit along with pad clips. Assemble the new brake pads with their clips and apply a C-clamp and worn brake pad to push the caliper pistons while safeguarding the caliper boots and pistons. Reposition the brake caliper while installing its two guide pin bolts which need to be tightened at 72 Nm (53 lb-ft). The brake fluid replenishment should use clean brake fluid then reinstall the tire and wheel before performing brake application to confirm proper function.