OEM 2008 Ford Mustang Wiper Switch

2008 Ford Mustang Wiper Switch Parts Questions & Experts Answers

• Q: How to service and repair the wiper switch and steering column multifunction switch on 2008 Ford Mustang?

  A: Service and repair of the wiper switch and steering column multifunction switch requires detachment of the instrument cluster finish panel by removing its retaining clips from the bezel. Service and repair of the wiper switch and steering column multifunction switch starts with removing the floor console finish panel and the LH A-pillar lower trim panel and the left center stack wing. Disengage the two screws holding the steering column opening cover while disconnecting the headlamp and courtesy light switch electrical wiring. You need to disable the four bolts which secure the steering column opening cover reinforcement before refitting these bolts with a torque setting of 9 Nm (80 lb-in). Work by properly tucking in and pushing the upper steering column shroud sides before using your fingers to remove the shroud and its residual screws from the lower part. Disconnect the turn signal/headlamp switch electrical connector before you remove the two screws needed to extract the turn signal/headlamp switch. The windshield wiper/washer switch electrical connector requires disconnecting before removing the switch by taking out its two screws. The installation ends by following the reverse order of uninstallation steps.