OEM 2009 Lincoln Town Car Automatic Transmission Filter

2009 Lincoln Town Car Automatic Transmission Filter Parts Questions & Experts Answers

• Q: How to Service and Repair the Automatic Transmission Filter for the 4R70E/4R75E on 2009 Lincoln Town Car?

  A: You should start servicing and repairing the automated transmission fluid filter of the 4R70E/4R75E by positioning the vehicle into NEUTRAL mode on a lift. You should initially loosen the transmission fluid pan bolts to drain the fluid completely before removing bolts and the pan allow removal with its gasket. After pulling down you need to remove the transmission fluid filter and its seal. The technician performs a visual examination along with cleaning of the transmission fluid pan along with its gasket and magnet. To install a new transmission fluid filter correctly you should use a small screwdriver to eliminate any remaining seal from the main control bore yet avoid damaging the bore during removal. A contaminated service calls for new filter and seal installation but otherwise any clean filter can remain for use if excessive contamination is absent. Position the new filter together with its seal before repositioning the pan magnet into the fluid pan. Use the transmission fluid pan gasket once more for installation only when it remains intact; perform cleaning then verification steps before application. Install the pan together with its gasket before torquing the pan bolts to 14 Nm (124 lb-in). End the transmission fluid filling process with 4.7L (5 qt) of approved transmission fluid while verifying the fluid reaches the proper level mark.