OEM Ford E-250 Automatic Transmission Filter

Ford E-250 Automatic Transmission Filter Parts and Q&A

• Filter Kit
  YC3Z-7A098-AA
  Q: How to Service and Repair the Automatic Transmission Filter for the 4R70W/4R75W on Ford E-250?

  A:

  A proper service includes filtering the 4R70W/4R75W automatic transmission fluid under two critical conditions. First users must abstain from applying any supplemental transmission fluid additives or cleaning agents because these substances may break down transmission components and impair its operation. Only the fluid which the manufacturer specifies should be utilized to avoid transmission failure. The transmission needs periodic automatic transmission fluid changes while major repairs requiring transmission removal include clutch, band, and bearing replacements that require complete flushing of the torque converter, transmission cooler, tubes to remove dirt. Changing the transmission fluid becomes necessary if any form of contamination emerges. You should use a hoist to maintain neutral gear and unscrew the transmission fluid pan bolts slightly to start draining fluid while keeping the bolts installed. Afterward remove the bolts and pan with the gasket. Wash and inspect the fluid pan by itself and its gasket and magnet while removing the fluid filter and seal. Workers should replace the new fluid filter and seal during transmission repair for contamination cases only. Otherwise they should use the existing filter if there is minimal contamination. The pan magnet should be inserted into the fluid pan while a reusable gasket becomes possible to use. Place the gasket and fluid pan onto their position before installing all pan bolts. Use clean automatic transmission fluid to fill the transmission up to 4.7 liters (5 quarts) until reaching the proper level.
• Filter Assembly
  XC3Z-7B155-F
  Q: How to Properly Install an Automatic Transmission Filter in a Torqshift System on Ford E-250?

  A:

  The repair and service process for the Torqshift automatic transaxle/transmission transmission fluid in-line filter begins with installing a new filter whenever a transmission has been overhauled with an original transmission fluid in-line filter. The transmission fluid in-line filter can only be installed when it was not part of the original vehicle equipment. New transmissions along with Ford approved remanufactured transmissions require the installation of the filter during replacement. Start by hoisting the vehicle to neutral gear position and cutting through the designated rubber hose segment. The transmission fluid in-line filter installation requires proper positioning since an improper direction will generate internal transmission damage. It is essential to check that the filter does not receive rubber hoses nor steel tubing which feature bends above 60 degrees to stop fluid flow obstruction. The next step involves cleaning a part of the transmission fluid pan before applying the sticker. Clean transmission fluid must be added to complete the procedure before performing correct operation checks and leak examination on the filter.