Other Name: Shaft - Front Axle; Axle Shaft Assembly; Axle Assembly
Position: Front Driver Side
Replaces: 3C3Z-3220-BA
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
1999-2007 Ford F-250 Super Duty | Harley-Davidson Edition, King Ranch, Lariat, XL, XLT | 10 Cyl 6.8 L GAS, 8 Cyl 5.4 L GAS, 8 Cyl 6.0 L DIESEL, 8 Cyl 7.3 L DIESEL
Other Name: Shaft - Front Axle; Axle Shaft Assembly; Axle Assembly
Position: Front Passenger Side
Replaces: 3C3Z-3219-BA
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
1999-2007 Ford F-250 Super Duty | Harley-Davidson Edition, King Ranch, Lariat, XL, XLT | 10 Cyl 6.8 L GAS, 8 Cyl 5.4 L GAS, 8 Cyl 6.0 L DIESEL, 8 Cyl 7.3 L DIESEL
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2005-2006 Ford F-250 Super Duty | King Ranch, Lariat, XL, XLT | 10 Cyl 6.8 L GAS
| Page 1 of 16 |Next >
1-20 of 308 Results
Ford F-250 Super Duty Drive Shaft
Welcome to our website where you can discover high-quality, genuine Ford F-250 Super Duty Drive Shaft. We offer an extensive inventory of OEM Ford F-250 Super Duty Drive Shaft at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.
Q: How to Service and Repair the Rear, One-Piece, 4X4 Drive Shaft with 137-, 141-, and 142-Inch Wheel Bases on Ford F-250 Super Duty?
A: In order to service the rear 4X4 drive/propeller shaft, it is imperative to raise the vehicle and mark the driveshaft at each of the flanges. Disassemble it, stripping it of bolts and U-joint retainers, replacing them after the third time. Install electrical tape around bearings cups, take away and attach driveshaft, being sure of proper alignment and applying Loctite(R) 242 on bolts.
Q: How to Service and Repair the Rear Two-Piece Drive Shaft on Ford F-250 Super Duty?
A: In order to fix the rear two-piece driveshaft, a vehicle should be placed on a hoist in neutral position. Decouple the axle and transmission to the driveshaft, which should then be supported by mechanic using wire. Wash and purify parts, and change broken parts. Apply lubrication to the Slip Yoke spline, reinstall the driveshaft with new bolts and reverse the steps that were followed.