Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2017-2020 Ford Fusion | Energi Platinum, Energi SE, Energi Titanium, Platinum Hybrid, S Hybrid, SE Hybrid, SEL Hybrid, Titanium Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2013-2016 Ford Fusion | Energi SE, Energi Titanium, S, S Hybrid, SE, SE Hybrid, Titanium, Titanium Hybrid | 4 Cyl 1.5 L GAS, 4 Cyl 1.6 L GAS, 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 4 Cyl 2.0 L PLUG-IN HYBRID EV-GAS (PHEV), 4 Cyl 2.5 L GAS
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2013-2020 Ford Fusion | Energi Platinum, Energi SE, Energi Titanium, Platinum, Platinum Hybrid, S, S Hybrid, SE, SE Hybrid, SEL, SEL Hybrid, Sport, Titanium, Titanium Hybrid | 4 Cyl 1.5 L GAS, 4 Cyl 1.6 L GAS, 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 4 Cyl 2.0 L PLUG-IN HYBRID EV-GAS (PHEV), 4 Cyl 2.5 L GAS, 6 Cyl 2.7 L GAS
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2006-2009 Ford Fusion | S, SE, SEL | 4 Cyl 2.3 L GAS, 6 Cyl 3.0 L GAS
Ford Fusion Vapor Canister
Welcome to our website where you can discover high-quality, genuine Ford Fusion Vapor Canister. We offer an extensive inventory of OEM Ford Fusion Vapor Canister at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.
Ford Fusion Vapor Canister Parts Questions & Experts Answers
Q: How to Service and Repair the Vapor Canister on Ford Fusion?
A: The evaporative emission control canister service requires the car to be in NEUTRAL position on a hoist system. Disconnecting the battery ground cable reduces electrical spark formation that could begin fuel vapor ignition. The service starts by detaching the electrical connector from the EVAP canister vent solenoid and then moving to disconnect the vapor tube from the dust separator. Use proper tools to detach the two quick connect fittings from the EVAP canister assembly vapor tube. You can remove the EVAP canister assembly through the process of unfastening two nuts and two bolts. To install the new canister it is vital to set the fasteners at 6 Nm (53 lb-in) torque before reversing the removal steps. The evaporative emission system leak test should follow the repair verification drive cycle to verify system functionality.