FordParts
My Garage
My Account
Cart
OEM 2001 Ford F-150 Blend Door Actuator
Air Blend Door Actuator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Blend Door Actuator found
2001 Ford F-150 Actuator Part Number: 2L3Z-19E616-BA
$42.94 MSRP: $69.27You Save: $26.33 (39%)Product Specifications- Other Name: Motor Assembly; HVAC Blend Door Actuator; HVAC Heater Blend Door Actuator
- Replaces: XL3Z-19E616-BA
- Base No.: 19E616
- Item Weight: 0.30 Pounds
- Item Dimensions: 8.7 x 7.9 x 8.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2L3Z-19E616-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2001 Ford F-150 Blend Door Actuator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2001 Ford F-150 Blend Door Actuator available at FordPartsDeal.com. You can confidently purchase our OEM 2001 Ford F-150 Blend Door Actuator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2001 Ford F-150 Blend Door Actuator Parts Q&A
- Q: How to Service and Repair a Blend Door Actuator on 2001 Ford F-150?A: The first step for servicing or repairing an air door actuator/motor is to take out the floor duct panel through pushpin extraction followed by expander clip release. The right-hand instrument panel brace can be removed after you detach its nut and bolt combination. Work to uninstall the left-hand panel lower nut and unscrew the three essential bolts to set the module away. The duct on the floor requires removal of two screws from both sides before extracting the duct. The procedure to disassemble the panel/floor door involves disconnecting the vacuum line connector from the vacuum control motor then removing screws before pulling out the rod from the door using vacuum control motor rotation to separate the panel/floor door. To detach the electronic blend door actuator fully you must disconnect the connector then take out the screws before lowering the device to free the actuator shaft. The installation procedure should follow the opposite order of decomposition.