OEM 2006 Ford Crown Victoria Brake Disc

2006 Ford Crown Victoria Brake Disc Parts Q&A

• Q: How to Service and Repair the Rear Brake Disc on 2006 Ford Crown Victoria?

  A: Before repairing the rear brake rotor/disc you should disconnect power to the air suspension system by placing the air suspension service switch in the off position to stop unexpected air spring inflations or deflations since this can shift the vehicle. Before starting the work you must depower any fire suppression systems which the vehicle might have. Park the vehicle in neutral mode on a hoist. First disconnect the brake pads before proceeding with the renovations. Also remove the adjustment hole access plug then use an adjusting tool to retract the parking brake shoe and lining by inserting it at the far end of the access plug slot and rotating it towards the backing plate. The hub-mount brake lathe should be used for required disc machining when necessary or a new brake disc should replace it if the disc exceeds specification limits. The installation procedure is reversed after cleaning all surfaces with brake parts cleaner. Brake parts cleaner will be used to remove rust and foreign substances from the brake disc as well as wheel and wheel hub before applying anti-seize to both hub flange and pilot area. Follow the removal steps in reverse order to install the system by putting the air suspension service switch to on if present and starting the fire suppression power if needed.