FordParts
My Garage
My Account
Cart
OEM 2006 Ford Crown Victoria Tail Pipe
Exhaust Tail Pipe- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Tail Pipes found
2006 Ford Crown Victoria Inlet Pipe Part Number: 4W7Z-5246-BA
Product Specifications- Other Name: Pipe - Exhaust; Exhaust Crossover Pipe; Direct-Fit Exhaust; Exhaust System Kit; Exhaust Pipe; Front Pipe
- Replaces: 3W7Z-5246-BA
- Base No.: 5246
- Item Weight: 20.90 Pounds
- Item Dimensions: 46.2 x 10.1 x 26.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4W7Z-5246-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Product Specifications- Other Name: Muffler Assembly - Centre And Rear; Exhaust Muffler, Right
- Position: Rear Passenger Side
- Replaces: 4W7Z-5230-DA, 5W7Z-5230-BA
- Base No.: 5230
- Item Weight: 22.40 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6W7Z-5230-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford Crown Victoria Inlet Pipe Part Number: 4W7Z-5246-AA
Product Specifications- Other Name: Pipe - Exhaust; Exhaust Crossover Pipe; Direct-Fit Exhaust; Exhaust System Kit; Exhaust Pipe; Front Pipe
- Replaces: 3W7Z-5246-AA
- Base No.: 5246
- Item Weight: 11.00 Pounds
- Item Dimensions: 36.7 x 20.4 x 12.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4W7Z-5246-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford Crown Victoria Tail Pipe
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Ford Crown Victoria Tail Pipe available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Ford Crown Victoria Tail Pipe as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Ford Crown Victoria Tail Pipe Parts Q&A
- Q: How to Service and Repair a Tail Pipe and Muffler with a Fire Suppression System on 2006 Ford Crown Victoria?A: The first step for muffler and tailpipe service requires depowering the fire suppression system for safety reasons. Park the vehicle at neutral gear position on the hoist platform. Start by taking off the lateral rear suspension arms and rear coil springs followed by rear suspension lateral nuts and clamp retention. You should then detach the two nuts and clamp and tighten them to 45 Nm (33 ft. lbs.) when reinstalling them. Go through the isolator to check for damage and deterioration while conducting an immediate replacement if necessary. Separate the isolator. A precise turning motion of the muffler and tailpipe assembly counterclockwise against the rear axle will let you remove it with its attached isolator. New exhaust fasteners should be employed for installation but the tightening will occur after all components are positioned. The fasteners should be alternately tightened following specifications to achieve uniform drawing power on the flange connections. The vehicle owner needs to perform a repower operation on the fire suppression system after finishing installation work.