Other Name: Deflector - Air; Radiator Support Splash Shield, Front Forward
Position: Front
Fits the following Lincoln Models:
MKZ | 2017-2020 | Base, Black Label, Black Label Hybrid, Hybrid, Premiere, Premiere Hybrid, Reserve, Reserve Hybrid, Reserve I, Reserve I Hybrid, Reserve II, Reserve II Hybrid, Select, Select Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 6 Cyl 3.0 L GAS
Q: How to service and repair the sunroof Air Deflector on Lincoln Continental?
A: You should start sunroof or moonroof windguard service and repair by taking out the roof sliding outer glass panel. First remove the roof sliding panel opening shield and sunshade until they reach half their length before lifting the shield to expose the tabs. The opening shield should be pushed all the way toward the rear and the sunshade should slide to the front. Start by using inward pressure on the spring-loaded rear guides until they free from the sunshade material before taking out the sunshade itself. Installation of this product requires executing the opposite steps of removal.
Q: How to Service and Repair the Sunroof Air Deflector on Lincoln Navigator?
A: The first step to service the sunroof or moonroof windguard involves opening the roof opening panel. Two air deflector tether screws need removal but focus on the right-hand side picture because the left-hand side operation follows the same steps. The installation of the sunroof or moonroof windguard demands tight screw installation at 1 Nm (9 lb-in). The service and repair of air deflectors require you to position the front section upwards before sliding it back and tilting it for shaft separation. The installation process should be finished by undoing all steps of removal.
Q: How to service and repair the sunroof or moonroof Air Deflector on Lincoln Town Car?
A: The service process starts with unfastening both sides of roof opening glass and water trough by removing the screws and continues with sunroof or moonroof windguard disassembly. The roof sliding panel opening shield can be released by moving it forward and lifting its center gently while the track is disengaged. The roof sliding panel opening shield requires flexing its center to feed its front and rear tabs into their track during installation. Secure the water trough beneath the side tabs by installing the screws and then reinstall the roof opening glass.