Ford E5TZ-17664-B
Water Pump, Front

The procedure for servicing and repairing the windshield washer pump starts with hood raising and suspension before removing the battery along with its tray using bolt removal. The washer pump removal starts with removing the nut followed by the bolt then disconnecting the filler hose and electrical connector and detaching the wiring harness locator before separating the windshield washer hose. Place a vessel under the hose to collect windshield washer fluid before the hose removal. After washer pump and reservoir extraction remove the washer pump from its place inside the reservoir. To reinstall the system begin with the opposite steps while adding windshield washer fluid to the reservoir. The electrical connection must avoid activation until the reservoir reaches its fill level and operating the windshield wiper pump must wait until filling completes. When reconnecting the battery it is essential to notice that your vehicle may exhibit irregular driving symptoms when it adapts its systems during which you need to drive 16 km (10 mi) at minimum for suitable system reconfiguration.

Service and repair operations for the windshield washer pump and reservoir start with a hood support while the battery along with the tray requires removal of its four bolts until the bolts reach a torque of 28 Nm (21 lb-ft) before reinstallation. You must first obtain the windshield washer fluid in a holding container before disconnecting the washer hose. The washer pump and reservoir removal starts with loosening the nut to 4 Nm (35 lb-in) for installation then moving to the bolt removal at 4 Nm (35 lb-in) tightening upon reinstallation. First disconnect the filler hose and electrical connector before separating the washer pump from the reservoir and the wiring harness locator followed by disconnection of the windshield washer hose. To install the washer pump into the reservoir complete the opposite steps of removal.

Start windshield washer pump repair and servicing by elevating the hood securely along with removing the battery and battery tray through bolt removal. After disconnecting the filler hose and electrical connector you should remove the washer pump and reservoir by taking out the nut and bolt then detaching the wiring harness locator from the washer pump and reservoir and disconnecting the windshield washer hose. When disconnecting the windshield washer hose it is vital to gather the washer fluid in a suitable container first. Pull out the washer pump from inside the reservoir after both components are removed. Users should perform installation by doing the removal steps in reverse order while adding windshield washer fluid into the washer reservoir. Pressing the electrical switch should wait until the reservoir gets filled while leaving the windshield washer pump off until the reservoir reaches its full level. After reconnecting the battery the vehicle needs to adapt its strategies during driving since abnormal functions may occur requiring at least 16 km (10 mi) for proper learning.

Ensure that windshield washer fluid is collected in a container after disconnecting the windshield washer hose.

Reverse the removal steps and fill the windshield washer reservoir with washer fluid.

Remember to fill the windshield washer reservoir.

Installation involves reversing the removal procedure.

Pull the rear window washer pump straight out from the reservoir.

Disconnect the washer hose and the electrical connector.

Take out the four screws along with the pin-type retainer to detach the right-hand front inner fender well.