Other Name: Handle Assembly - Door Outer; Exterior Door Handle
Position: Passenger Side
Replaces: JL1Z-7822404-BAPTM, JL1Z-7822404-BBPTM
Fits the following Ford Models:
Expedition | 2018-2024 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, Timberline, XL, XL STX, XLT | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS
Other Name: Handle Assembly - Door Outer; Exterior Door Handle
Position: Driver Side
Replaces: JL1Z-7822405-CBPTM, JL1Z-7822405-CAPTM
Fits the following Ford Models:
Expedition | 2022-2024, 2018-2020 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, Timberline, XL, XL STX, XLT | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS
| Page 1 of 51 |Next >
1-20 of 1015 Results
Ford Door Handle Parts Questions & Experts Answers
Q: How to service the exterior front door handle on Ford Explorer?
A: The service procedure for an exterior front door handle starts with removing the front door trim panel as well as setting aside the watershield. The service requires removal of both the screw and energy absorbing foam pad. The service requires you to disconnect the rod that controls door lock cylinder action. Rough service requires opening the clip to detach the exterior front door handle actuating rod following which the two exterior front door handle nuts must be removed while installation requires a 9 Nm (80 lb-in) torque setting. The last step involves removal of the exterior front door handle followed by installation of the new handle through its reverse removal steps.
Q: How to Service and Repair the Front Door Handle on Ford Focus?
A: The repair process for a front door exterior handle begins by detaching the front door trim panel while carefully removing watershield from the edges so that adhesive damage to re-bonding does not occur. First cut the grommet covering the exterior door handle access hole on the door before unlatching the screw which separates the door lock cylinder bezel. Continue without uninstalling the bezel itself. To start the process remove the door lock cylinder bezel followed by the exterior door handle which can be released through sliding it before removing the exterior door handle and gaskets. Reverse the process used for removal to install the parts.
Q: How to Service and Repair the Front Door Handle on Ford Mustang?
A: Service and maintenance of the front door exterior handle requires starting with the door window glass lifted to maximum height and removing the door trim panel. The service procedure demands the removal of the door lock cylinder whenever installed. When installing its actuating rod into the retaining clip users must push upward. After this users should open the exterior door handle actuating clip to disconnect the rod. The exterior door handle requires removal by first detaching its right-hand side studs then pulling it forward through the hole. The new exterior handle requires insertion through the door panel to connect the bellcrank followed by sliding it forward for installation. Determine each exterior door handle stud position correctly and tighten them with a torque of 9 Nm (80 lb-in). The door latch must be kept in neutral before using the exterior door handle actuating rod to push upward while connecting it into the clip. To finish the installation procedure install the door lock cylinder and return the door trim panel.