Expedition | 2018-2021 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, XL, XLT | 6 Cyl 3.5 L GAS
Other Name: Panel Assembly - Console; Console Trim Panel, Rear
Position: Rear
Fits the following Ford Models:
Expedition | 2018-2020 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, XL, XLT | 6 Cyl 3.5 L GAS
Other Name: Panel Assembly - Console; Console Panel, Center Lower
Position: Center Lower
Fits the following Ford Models:
Expedition | 2007-2010 | Eddie Bauer, EL Eddie Bauer, EL King Ranch, EL Limited, EL XLT, Funkmaster Flex Edition, King Ranch, Limited, XLT | 8 Cyl 5.4 L FLEX, 8 Cyl 5.4 L GAS
Q: How to remove and install the front floor Center Console Base on Ford Explorer?
A: Begin by dismantling the front floor console through removal of the floor console finish panel mat followed by removing the floor console center finish panel screw and finally the center finish panel. The first step involves disconnecting the floor console electrical connector before uninstalling the two mounting screws that secure it. Start by moving front seating forward to access the console areas followed by removing any floor console bolt cover that exists. Install the four floor console bolts by tightening them to 9 Nm (80 lb-in) measurements. Unclip the two front edges on the floor console and separate the console from its place. Implementation follows the opposite order of the uninstall process.
Q: How to remove and install the Center Console Base on Ford Mustang?
A: The first procedure for removing the floor console from all vehicles includes disconnecting the battery ground cable and applying the parking brake. Automatic transmission vehicles require placement of the selector lever in position number one. Those who drive with manual transmission should take out the gearshift lever handle first. First disconnect the electrical connector from the floor console then remove its finish panel. Open the floor console glove compartment door followed by removing the screws on the floor console while disconnecting its electrical connector. The last step involves unscrewing the console and then removing the floor console. The floor console installation requires executing the steps in reverse order when compared to removal.
Q: How to service the Center Console Base on Ford Ranger?
A: Service of the floor console starts with removing the two front seat center armrest covers along with all four armrest bolts to separate it from the seat. Start by taking out the beverage tray followed by the removal of the floor console through screw removal and console extraction. The installation follows the reverse steps of removal.