Other Name: Shaft Assembly - Steering; Center Shaft; Upper Shaft
Replaced by: L1MZ-3E751-C
Fits the following Lincoln Models:
Aviator | 2020-2023 | Base, Black Label, Black Label Grand Touring, Grand Touring, Livery, Reserve | 6 Cyl 3.0 L GAS, 6 Cyl 3.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Continental | 2017-2020 | 80th Anniversary Coach Door Edition, Base, Black Label, Coach Door Edition, Livery, Premiere, Reserve, Select | 6 Cyl 2.7 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.7 L GAS
Continental | 2017-2020 | 80th Anniversary Coach Door Edition, Base, Black Label, Coach Door Edition, Livery, Premiere, Reserve, Select | 6 Cyl 2.7 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.7 L GAS
MKZ | 2017-2020 | Base, Black Label, Black Label Hybrid, Hybrid, Premiere, Premiere Hybrid, Reserve, Reserve Hybrid, Reserve I, Reserve I Hybrid, Reserve II, Reserve II Hybrid, Select, Select Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 6 Cyl 3.0 L GAS
Continental | 2017-2020 | 80th Anniversary Coach Door Edition, Base, Black Label, Coach Door Edition, Livery, Premiere, Reserve, Select | 6 Cyl 2.7 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.7 L GAS
Other Name: Column Assembly - Steering; Column Assembly
Replaced by: P1MZ-3C529-C
Fits the following Lincoln Models:
Aviator | 2020-2023 | Base, Black Label, Black Label Grand Touring, Grand Touring, Livery, Reserve | 6 Cyl 3.0 L GAS, 6 Cyl 3.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Q: How to service the deployable steering column safely on Lincoln Mark LT?
A: To maintain the deployable steering column, depower the SRS and deploy equipment in the field keeping people 9.14 meters away. Reach electrical connector by moving column downwards or removing it. Make a jumper harness using 20-gauge wires, attach to the column and install and use with a 12-volt battery. Allow 10 minutes to pass and make an approach.
Q: How to service the deployable steering column on Lincoln Town Car?
A: Depower the SRS and reach the electrical connector in order to service the deployable steering column. In the event that there is no pigtail cut the wires to leave 4 inches. Make a jumper harness using two 20-gauge wires and connect them and ensure that the distance between them is 30 feet. Install with battery 12 volts and leave 10 minutes then dispose.