Aviator | 2020-2023 | Base, Black Label, Black Label Grand Touring, Grand Touring, Livery, Reserve | 6 Cyl 3.0 L GAS, 6 Cyl 3.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Other Name: Cover; Air Cleaner Cover, Upper; Air Filter Housing
Position: Upper
Fits the following Lincoln Models:
Aviator | 2020-2023 | Base, Black Label, Black Label Grand Touring, Grand Touring, Livery, Reserve | 6 Cyl 3.0 L GAS, 6 Cyl 3.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Q: How to service and repair the Air Filter Box assembly on Lincoln Aviator?
A: Service and repair operations for the air filter box assembly must start from removing the engine appearance cover. Start by taking away the components according to their specified sequence. When removing the air filter box tray, the user should first pull it upward before pulling it away from the body. The installation of the air filter box assembly requires following the opposite steps of removal.
Q: How to service the Air Filter Box on Lincoln LS?
A: Start the servicing procedure by first taking off the clamp and pipe fitting of the air filter box outlet from its assembly before reinstallation requires a torque of 4 Nm (35 lb-in). The service process begins by disconnecting the mass air flow (MAF) electrical connector before extracting the bolt that secures the air filter box assembly. Both components need to be tightened to 4 Nm (35 lb-in) after installation is finished. Service of the air filter box requires complete removal of the air filter box assembly to reach the air filter element and the air filter box tray should be split from the air filter box cover by unsnapping it. During the installation step perform a reverse procedure of removal while ensuring the alignment tabs help the proper alignment between the air filter box cover and air filter box tray when removal of the tray occurred.
Q: How to Service the Air Filter Box on Lincoln MKZ?
A: The service of the air filter box begins when technicians disconnect first the MAF sensor electrical connection then remove the wiring harness retainer. The procedure continues with unfastening the clamp to detach the air filter box outlet pipe from the air filter box before tightening it to 5 Nm (44 lb-in) when reattaching. Tighten the three bolts which secure the air filter box assembly to 5 Nm (44 lb-in) when reinstalling. Wipe away the air filter box assembly by first removing it from the rubber grommets and inlet pipe then separating each of the two air filter box feet. Check that the two air filter box feet fit properly into the rubber grommets located below the air filter box assembly before verifying the sealed outlet pipe to minimize engine air intake. The process ends after performing the steps in reverse from removal.