E-150 Club Wagon | 2003 | Chateau, XL, XLT | 6 Cyl 4.2 L GAS
E-150 Econoline | 1999-2002 | Base, XL | 6 Cyl 4.2 L GAS
E-150 Econoline Club Wagon | 1999-2002 | Chateau, Custom, XL, XLT | 6 Cyl 4.2 L GAS
E-250 | 2003 | Base | 6 Cyl 4.2 L GAS
E-250 Econoline | 1999-2002 | Base, XL | 6 Cyl 4.2 L GAS
Escape | 2001-2007 | Limited, XLS, XLT, XLT No Boundaries, XLT Sport | 6 Cyl 3.0 L GAS
Explorer | 1999-2005 | Eddie Bauer, Limited, NBX, Postal, Sport, XL, XL Fleet, XLS, XLS Sport, XLT, XLT Sport | 6 Cyl 4.0 L FLEX, 6 Cyl 4.0 L GAS, 8 Cyl 5.0 L GAS
Explorer Sport | 2001-2003 | Base, XLS, XLT | 6 Cyl 4.0 L GAS
Explorer Sport Trac | 2001-2005 | Adrenalin, Base, XL, XLS, XLT | 6 Cyl 4.0 L FLEX, 6 Cyl 4.0 L GAS
Q: How to Service the Mass Air Flow Sensor on Ford Mustang?
A: Service of the MAF sensor starts with disconnecting the battery ground cable. The MAF sensor detachment requires disconnecting the air cleaner and duct assembly followed by releasing its four tabs. The MAF sensor requires removal after disconnecting the connector and removing its attached nuts. Following the removal steps in reverse order will install the mass air flow sensor without damaging its calibrated hot wire sensing element or housing to avoid sensor failure.
Q: How to Properly Handle the Mass Air Flow Sensor for Maintenance on a Ford Ranger?
A: Service of the mass air flow (MAF) sensor begins by disconnecting its electrical connector. Following removal of the electrical connector you must detach the MAF sensor by taking out its two securing bolts. Dispose of the worn gasket. Secure the new sensor by turning its bolts to a torque of 11 Nm (8 lb-ft). Any handling of MAF sensing elements which reside inside the airflow bypass should be avoided because damage could cause the system to fail. The MAF sensor module operates with its body as a calibrated unit during installation. Both the removal and installation must proceed in reverse order to ensure the use of a new gasket.
Q: How to service the Mass Air Flow Sensor on Ford Explorer?
A: Service of the Mass Air Flow (MAF) sensor requires you to disconnect the battery ground cable first. You should not alter the sensing elements in the air flow bypass section of the MAF body since the MAF sensor electronics module and body function as an integrated unit during servicing. Service the components according to the given order. Install the components in the reverse order of removal steps.